Control Panel; System Use - Immergas MAGIS PRO 12 V2 Instructions And Recommendations

2.3 CONTROL PANEL

Key (Fig. 23):
1 - Operating mode (winter - air conditioning - summer - stand-
by - off) and parameter confirm button
2 - Menu selection button
3 - Reset and exit menu button
4 - Domestic hot water temperature selection buttons
5 - Heating system temperature selection buttons
6 - Indoor unit pressure gauge
7 - Remote control connection (optional)
8 - Outdoor unit in operation
9 - Not used on this model
10 - Dispensed output level
11 - Operation with external temperature probe active (optional)
2.4

SYSTEM USE

Before ignition, make sure the system is full of water, checking that the pressure gauge needle (6) points to a value between 1 and
1.2 bar and make sure that the chiller circuit has been filled as described in the outdoor unit instructions booklet.
– Press the button (1) until the display switches on. The system now goes back to the state prior to switch-off. (During ignition, the display
shows in sequence: display segments all lit, parameter A011, parameter A013).
– If the indoor unit is in stand-by, press the button (1) again to activate it. If this is not the case, go to the next point.
– Then press the button (1) in sequence and set the system to summer
12 - Connection to other Immergas units
13 - Central heating room mode function active
14 - Temperature indicator, indoor unit info and error codes
15 - Room cooling mode operation active
16 - Operation in cooling mode
17 - Operation in winter mode
18 - Operation in summer mode
19 - Stand-by Mode
20 - Not used on this model
21 - Blocked indoor unit, it needs to be unblocked by pressing the
"RESET" button
22 - Operation in dehumidification mode
23 - DHW production phase operating mode active
, winter , or air conditioning position
23
.
33