Parameters For Filling In The Package Fiche - Immergas MAGIS PRO 12 V2 Instructions And Recommendations

4.21 PARAMETERS FOR FILLING IN THE PACKAGE FICHE

Should you wish to install an assembly starting from the Magis Pro V2 package, use the package fiche shown in (Fig. 60).
To complete it properly, fill the relevant spaces (as shown in the package fiche facsimile Fig. 59) with the values shown in tables "Parame-
ters to fill in the low temperature package fiche (30/35)", "Parameters to fill in the average temperature package fiche (47/55)".
The remaining values must be obtained from the technical data sheets of the products used to make up the assembly (e.g. solar devices,
integration heat pumps, temperature controllers).
Use sheet (Fig. 60) "assemblies" related to the central heating function (e.g.: heat pump + temperature controller).
Since the product is standard supplied with a temperature controller, the package fiche must always be completed.
Facsimile for filling in the package fiche for room central heating systems.
Temperature control
From temperature
control board
Supplementary boiler
From boiler board
Solar contribution
From the board of the solar device
Dimensions of the
manifold (in m
( 'III' x
climate conditions
climate conditions
Colder:
the heat loss in the distribution system and the size of the products compared to the size and
features of the building.
Class I = 1 %, Class II = 2 %,
Class III = 1.5 %, Class IV = 2 %,
Class V = 3 %, Class VI = 4 %,
Class VII = 3.5 %, Class VIII = 5 %
Volume of the
) tank (in m )
2 3
+ 'IV' x ) x 0.45 x (
G F E D
< 30 % ≥ 30 % ≥ 34 % ≥ 36 % ≥ 75 % ≥ 82 % ≥ 90 % ≥ 98 % ≥ 125 %≥ 150 %
%
- 'V' =
(%)
( - 'I' ) x
tank
A* = 0.95, A = 0.91,
B = 0.86, C = 0.83,
manifold (in %)
D-G = 0.81
/ 100) x
C B A A
ter climate conditions
Hotter:
%
'I'
+
%
-
%
"II" =
+
%
=
%
A A
+ ++ +++
%
+ 'VI' =
59
105