Immergas 3.033210 Instruction And Warning Book page 48

1.16 KIT CONNECTION CABLE PATH DIAGRAM.
The power cable (l) must follow the prescribed route (Fig. 25).
If the power supply cable is damaged, it must be replaced by a special cable or assembly,
which are only available from the manufacturer or its Authorised After-Sales Technical
Assistance Centre. It is recommended to contact a qualified company (e.g. the Authorised
After-Sales Technical Assistance Centre) for replacement to avoid a hazard.
To protect from possible dispersions of DC voltage, it is necessary to provide a type A
differential safety device.
The power supply cable must be connected to a 230V ±10% / 50Hz mains supply respec-
ting L-N polarity and earth connection; this network must also have a multi-pole circuit
breaker with class III overvoltage category in compliance with installation regulations.
48 48
1
M8
M6
B12
B11
A12
25