PRE-INSTALLATION INFORMATION
Sink specification guidelines
Using a specially designed test method, Dyson engineers
tested a wide range of sinks to assess their compatibility with
the Dyson Airblade Wash+Dry hand dryer. For recommended
sinks, please contact dyson
AU: 1800 426 337 or NZ: 0800 397 667
Porcelain or brushed metal sinks are ideal.
Sinks with highly polished surfaces should be avoided
e.g. reflective chrome.
Fig.1
350 mm minimum
350mm minimum
350mm minimum
Fig.3
385 mm minimum
385mm minimum
Sink dimensions
(All internal measurements unless otherwise stated)
Fig.1 Width of sink minimum: 350 mm, Front to back of sink minimum: 300 mm
Fig.2 Maximum depth of sink for Tall Neck Tap (WD05) only: 200 mm
(External measurement of vessel/pedestal sink.)
Tap mounting
The tap stem (measured from the outside diameter) should
be mounted 15-40 mm from the outside edge of the sink.
There should be a minimum of 290 mm between a tap centre
and a side wall. When multiple taps are installed side-by-side,
tap centres should be a minimum of 580 mm apart. This allows
sufficient space for mounting the motor bucket, as well as sufficient
shoulder room for users.
Fig.2
385mm minimum
Fig.3 Minimum distance from tap centre to top of sink (WD06 only) 100 mm.
Front edge of sink (all types – pedestal, recessed, slab) to wall minimum 385 mm.
Internal depth of sink minimum (for all taps): 100 mm
385mm minimum