NETGEAR Nighthawk RS700 User Manual page 54

After you click the Apply button, the router automatically detects the information in
the following fields:
• Router's IPv6 Address on WAN: This field shows the IPv6 address that is acquired
for the router's WAN (or Internet) interface. The number after the slash (/) is the
length of the prefix, which is also indicated by the underline (_) under the IPv6
address. If no address is acquired, the field displays Not Available.
• Router's IPv6 Address on LAN: This field shows the IPv6 address that is acquired
for the router's LAN interface. The number after the slash (/) is the length of the
prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
6. (Optional) In the DHCP User Class (If Required) field, enter a host name.
Most people can leave this field blank, but if your ISP gave you a specific host name,
enter it here.
7. (Optional) In the DHCP Domain Name (If Required) field, enter a domain name.
You can type the domain name of your IPv6 ISP. Do not enter the domain name for
the IPv4 ISP here. For example, if your ISP's mail server is mail.xxx.yyy.zzz, type
xxx.yyy.zzz as the domain name. If your ISP provided a domain name, type it in this
field. For example, Earthlink Cable might require a host name of home, and Comcast
sometimes supplies a domain name.
8. Select an IPv6 Domain Name Server (DNS) Address radio button:
• Get Automatically from ISP: Your ISP uses DHCP to assign your DNS servers.
Your ISP automatically assigns this address. Unless the ISP assigns DNS servers
through DHCPv6, this option uses the DNS servers assigned by the ISP for the
IPv4 connection.
• Use These DNS Servers: If you know that your ISP requires specific servers, select
this option. Enter the IP address of your ISP's primary DNS server. If a secondary
DNS server address is available, enter it also.
9. Select an IP Address Assignment radio button:
• Use DHCP Server: Use this method if devices on the LAN cannot receive an IPv6
address through auto configuration but must receive the IPv6 address through
a DHCP server.
• Auto Config: This is the default setting.
This setting specifies how the router assigns IPv6 addresses to the devices on your
home network (the LAN).
10. (Optional) Select the Enable RIPng check box.
Specify Your Internet Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700
54 User Manual