Table of Contents
Advertisement
The page adjusts.
7. From the Internet Service Provider menu, select PPTP or L2TP as the encapsulation
method.
The page adjusts again.
8. In the Login field, enter the login name that your ISP gave you.
This login name is often an email address.
9. In the Password field, type the password that you use to log in to your Internet
service.
10. From the Connection Mode menu, select Always On, Dial on Demand, or Manually
Connect.
11. To change the number of minutes until the Internet login times out, in the Idle
Timeout (In minutes) field, type the number of minutes.
This is how long the router keeps the Internet connection active when no one on the
network is using the Internet connection. A value of 0 (zero) means never log out.
12. If your ISP gave you fixed IP addresses and a connection ID or name, type them in
the My IP Address, Subnet Mask, Server Address, Gateway IP Address, and
Connection ID/Name fields.
If your ISP did not give you IP addresses, a connection ID, or name, leave these fields
blank. The connection ID or name applies to a PPTP service only.
13. Select a Domain Name Server (DNS) Address radio button:
• Get Automatically from ISP: Your ISP uses DHCP to assign your DNS servers.
Your ISP automatically assigns this address.
• Use These DNS Servers: If you know that your ISP requires specific servers, select
this option. Enter the IP address of your ISP's primary DNS server. If a secondary
DNS server address is available, enter it also.
14. Select a Router MAC Address radio button:
• Use Default Address: Use the default MAC address.
• Use Computer MAC Address: The router captures and uses the MAC address
of the computer that you are now using. You must use the one computer that the
ISP allows.
• Use This MAC Address: Enter the MAC address that you want to use.
15. Click the Apply button.
Specify Your Internet Settings
Nighthawk WiFi 7 Tri-Band Router Model RS700
40
User Manual
Advertisement
Table of Contents
