Change A Port Triggering Rule - NETGEAR Nighthawk RS700 User Manual

• Service Type: Select the protocol (TCP or UDP) that is associated with the service
or application.
• Triggering Port: Enter the number of the outbound traffic port that will trigger
opening of the inbound ports when traffic is sensed.
• Connection Type: Select the protocol (TCP or UDP) that is associated with the
inbound connection. If you are unsure, select TCP/UDP.
• Starting Port: Enter the start port number for the inbound connection.
• Ending Port: Enter the end port number for the inbound connection.
8. Click the Apply button.
Your settings are saved and the service or application is added to the Port Triggering
Portmap Table on the Port Forwarding / Port Triggering page.
By default, the rule for the new service or application is enabled.

Change a port triggering rule

You can change an existing port triggering rule.
To change a port triggering rule:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Port Forwarding / Port Triggering.
The Port Forwarding / Port Triggering page displays.
5. Select the Port Triggering radio button.
The port triggering settings display.
6. In the Port Triggering Portmap Table, select the radio button for the rule.
Manage Port Forwarding and
Port Triggering
Nighthawk WiFi 7 Tri-Band Router Model RS700
194 User Manual