Table of Contents
Advertisement
5. In the Traffic Control section, clear the Disconnect and disable the Internet
connection check box.
6. Click the Apply button.
Your settings are saved.
Set the NTP server
By default, the router uses the NETGEAR Network Time Protocol (NTP) server to sync
the network time. You can change the NTP server to your preferred NTP server.
To set the NTP server:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter http://www.routerlogin.net.
A login window displays.
3. Enter the router admin user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. The user name and password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Administration > NTP Settings.
The NTP Settings page displays.
5. Select an NTP server radio button:
• Use the default NETGEAR NTP server: Use the preset NETGEAR NTP server.
• Set your preferred NTP server: Enter the name or IP address of your preferred
server.
6. If you select the Set your preferred NTP server radio button, enter the NTP server
domain name or IP address in the field below the radio button.
7. Click the Apply button.
Your settings are saved.
Manage and Monitor Your
Router
Nighthawk WiFi 7 Tri-Band Router Model RS700
146
User Manual
Advertisement
Table of Contents
