Table of Contents
Advertisement
Power button board
Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the service cover (see
a.
Battery (see
b.
Hard drive (see
c.
Keyboard (see
d.
Top cover (see
e.
System board (see
Remove the power button board:
1.
Remove the two Phillips PM2.0×3.25 screws (1) that secure the power button board to the top cover.
2.
Remove the power button board (2) and cable.
Reverse this procedure to install the power button board.
118 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service cover on page
Battery on page
69)
Hard drive on page
71)
Keyboard on page
81)
Top cover on page
89)
System board on page
67), and then remove the following components:
107)
Spare part number
730552-001
Advertisement
Table of Contents
