Table of Contents
Advertisement
Fingerprint sensor assembly
Table 6-7
Fingerprint sensor assembly, bracket, cable, and insert descriptions and part numbers
Description
Fingerprint sensor assembly
Fingerprint sensor bracket (included in Bracket Kit)
Fingerprint sensor cable (included in the Cable Kit)
Fingerprint sensor insert (included in Plastics Kit; for use in models without a fingerprint sensor)
Before removing the fingerprint sensor assembly, follow these steps:
1.
Prepare the computer for disassembly
2.
Place the computer in Battery Safe mode
3.
Remove the following components:
a.
Bottom cover
b.
Battery
c.
Hard drive
Remove the fingerprint sensor assembly:
1.
Disconnect the cable from the ZIF connector on the fingerprint sensor (1).
2.
Slide the bracket toward the inside of the computer, and then lift it off the fingerprint sensor board (2).
TIP:
48
Chapter 6 Removal and replacement procedures for authorized service provider parts
(Bottom cover on page
(Battery on page
40).
(Hard drive on page
A tool may be required to push and disengage the bracket.
(Preparation for disassembly on page
(Battery Safe mode on page
32).
37)
Spare part number
L44516-001
L44586-001
L52216-001
L44551-001
31).
31).
Advertisement
Table of Contents
