Table of Contents
Advertisement
Current Probes
Certifications
Teledyne LeCroy certifies compliance to the following standards as of the time of
publication.
European Council
The probe bears this mark to indicate it conforms to all applicable
European Council standards. Please see the EC Declaration of
Conformity document shipped with your product for current
certifications.
EC D
ECLARATION OF
The probe meets the intent of EC Directive 2014/30/EU for Electromagnetic
Compatibility.
,
EN IEC 61326-1:2021 EMC requirements for electrical equipment for
measurement, control, and laboratory use. 1, 2
EN IEC 61326-2-1:2021 Particular requirements for sensitive test and
measurement equipment for EMC unprotected applications.
1 Emissions which exceed the levels required by this standard may occur when the instrument is
connected to a test object.
2 This product is intended for use in nonresidential areas only. Use in residential areas may cause
electromagnetic interference.
EC D
ECLARATION OF
The probe meets the intent of EC Directive 2014/35/EU for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-1:2010+A1:2019 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1: General requirements
EN IEC 61010-2-032:2021 Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use – Part 2-032: Particular Requirements
for Hand-Held and Hand Manipulated Current Sensors for Electrical Test and
Measurement.
E
-
-L
H
ND
OF
IFE
ANDLING
The probe is marked with this symbol to indicate that it complies with the
applicable European Union requirements to Directives 2012/19/EU on
Waste Electrical and Electronic Equipment (WEEE).
24
C
- EMC
ONFORMITY
C
– S
ONFORMITY
AFETY
/ WEEE
Advertisement
Table of Contents
