Table of Contents
Advertisement
Care and Maintenance
Cleaning
The exterior of the probe and cable should be cleaned only using a soft cloth
moistened with water or isopropyl alcohol. The use of abrasive agent, strong
detergents or other solvents may damage the probe.
CAUTION: The probe casing is not sealed and should never be
immersed in any fluid.
Calibration Interval
The recommended calibration interval is one year. Adjustment should only be
performed by qualified personnel. (A performance verification procedure is
included in this manual.)
Service Strategy
Defective probes must be returned to a Teledyne LeCroy service facility for
diagnosis and exchange. A defective probe under warranty will be replaced with a
factory refurbished probe. A probe that is not under warranty can be exchanged for
a factory refurbished probe. A modest fee is charged for this service. A defective
probe must be returned in order to receive credit for the probe core.
Troubleshooting
If the probe is not operating properly the problem may be the way in which it is
used. Before assuming the probe is defective, perform the following
troubleshooting procedures:
1. Verify the test instrument is running the required firmware (10.4.x.x or
higher).
2. If the waveform is inverted, check that the arrow on the slider is in the
direction of the current flow.
3. If there is no signal, check that the slider is closed and locked.
User Manual
21
Advertisement
Table of Contents
