Audio Jack Board Cable - HP ENVY x360 Maintenance And Service Manual

2. Remove the four Phillips M2.0 × 3.2 screws (2) that secure the touchpad to the computer on the
bottom edge of the touchpad.
3. Remove the touchpad bracket (3).
The touchpad bracket is not available as a spare part.
4. Lift the rear edge of the touchpad (4) until it rests at an angle.
5. Remove the touchpad (5) by sliding it up and away from the computer at an angle.
To replace the touchpad and bracket, reverse the removal procedures.

Audio jack board cable

To remove the audio jack board cable, use this procedure and illustration.
NOTE: The audio jack board cable is available using spare part number N41012-001.
Before removing the audio jack board cables, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the audio jack board cable:
1. Release the ZIF connector (1) the audio jack board cable is connected to, and then disconnect the
audio jack board cable from the system board.
2. Release the ZIF connector (2) the audio jack board cable is connected to, and then disconnect the
audio jack cable from the audio jack board.
52 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
30).
30).