Solid-State Drive - HP ENVY x360 Maintenance And Service Manual

6. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective
sleeve on the antenna connector, as shown in the following illustration.
To replace the WLAN module, reverse the removal procedures.
NOTE: The WLAN module is designed with a notch to prevent incorrect insertion.

Solid-state drive

To remove the solid-state drive, use this procedure and illustration.
Table 5-6 Solid-state drive descriptions and part numbers
Description
1 TB, M.2 2280, PCIe-NVMe, value solid-state drive
512 GB, M.2 2280, PCIe, NVMe, value solid-state drive
512 GB, 2280, PCIe-4 × 4, NVMe, solid-state drive with TLC
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1. Remove the shield material (1) that covers the solid-state drive and solid-state drive shield.
2. Remove the solid-state drive shield (2) from the system board.
The solid-state drive shield is not available as a spare part.
36 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page 30).
Spare part number
L85370-005
L85364-005
M17436-005
Battery on page 31).
30).