Advertisement
Available languages
Available languages
assembly instructions
and precautions
STEP 1
STEP 2
Front Cross
Brace
Frame
Socket
STEP 3
Commode
Bucket
1.
Remove commode from packaging.
2.
Unfold commode and stand upright.
3.
Adjust the sides of commode frame perpendicular to the
back frame.
4.
Attach front cross brace by depressing brass push pins
and sliding brace into side frame socket. Attach on both
sides. Be sure brass push pins "snap" through holes.
5.
Attach back brace by depressing brass push pins and
sliding back brace into receptacle located on back of
cross brace. Be sure brass push pins "snap" through holes.
6.
Lower commode bucket into bracket and attach lid onto
back of frame.
7.
To unfold, depress push pins on back support and remove.
Depress push pins on front frame and slide frame from side.
Rev.2.04.28.14
1.
2.
Push Pins
Side
Frame
1.
2.
Back
Brace
3.
Commode
Lid
4.
5.
6.
7.
8.
adjusting leg height
Before use, adjust height of each leg to
your specific needs, making sure all legs
are at the same height. When desired
height is reached, lock legs into place by
aligning buttons into proper holes, per
illustration.
To be sure legs are locked into place by
pushing down on or by pulling legs.
additional precautions
Toilet seat must be in down position before use.
Failure to do so may result in breakage of commode
and possible injury.
Do NOT install commode without first reading and
understanding this assembly and instruction sheet.
If you can not understand these instructions, contact a
healthcare dealer or technical professional before
attempting to install. Otherwise, injury or damage
may occur.
Inspect all parts for shipping damage before assembly.
If there is shipping damage - DO NOT USE. Contact
dealer/carrier for further instructions.
Make certain that the height adjusting snap buttons fully
protrude through the same respective hole of each
leg extension. This will ensure that the leg extensions
are securely locked in position and an even height is
achieved (see Figure 1).
Ensure ALL screws, nuts and/or bolts are tightened.
Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace any or
all if any of these imperfections exist.
All four leg extensions with rubber tips MUST touch the
floor simultaneously at all times.
Users with limited physical strength should be supervised
or assisted while using commode.
FIGURE 1
Advertisement
