Advertisement
Q1: Do I need to cut off power when replacing batteries after installation?
A1: There is no need to cut off power. Your safety is ensured as long as the wiring is done correctly, with the exposed wire length being less than 7 mm and no wire short-circuiting to the metal wire box or the fixing screws of the switch.
Q2: When do I need to replace batteries?
A2: If the LED blinks 3 times when you press the switch, the batteries need replacing.
Q3: What types of batteries can I use?
A3: 1.5 V AAA/LR03 alkaline batteries are recommended.
Note: Too high voltage might damage the switch. Check the max output voltage with the manufacturers if you use other types of batteries.
Install your switch following the wiring diagram below. Make sure you turn off the circuit breaker first.
Blinking red quickly: Enter pairing mode.
Solid red for 5s: Pairing is complete.
Blinking 3 times when pressing the switch: Low battery.
Press and hold for 5s: Reset the switch and enter pairing mode.
For technical support, user guides, FAQs, warranty and more, please visit www.tapo.com/support/
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the tapo S210 that isn't answered in the manual? Leave your question here.