Franklin 19083 - Throw And Field Return Trainer Assembly Manual

Also See for 19083:

Assembly instructions (2 pages)

Table of Contents

Contents

1 Parts List
2 Assembly
3 To attach the net
4 Documents / Resources
- 4.1 References
- 4.2 Download manual

Franklin 19083 - Throw And Field Return Trainer Assembly Manual

Parts List

PART	AMOUNT	DESCRIPTION	REPLACEMENT PART#
1	1	Top Elbow Tube	19083-R1
2	1	Top Elbow Tube	19083-R2
3	2	Bottom Middle Tubes	19083-R3
4	2	"Y" Tube	19083-R4
5	2	Back Middle Tubes	19083-R5
6	1	Bottom Elbow Tubes	19083-R6
7	1	Bottom Elbow Tubes	19083-R7
8	1	Back Bottom Elbow Tube	19083-R8
9	1	Back Bottom Elbow Tube	19083-R9
10	1	Net	19083-R10
11	1	Strike Zone Ribbon	19083-R11
12	24	S-Hook Bungees	19083-R12
13	4	Plastic Blocks	19083-R13
14	4	Ground Stakes	19083-R14

Assembly

Remove all components from the package and confirm all parts are included. Please reference the frame assembly diagram below (see figure 1):
Place the S-Hook Bungees on the following tubes: 1, 2, 3, 4, 6, 7
Place the 4 Plastic Blocks on the following tubes: 6, 7, 8, 9
Attach all of the tubes together to assemble the frame as pictured in the assembly drawing

To attach the net

Spread out the net and find the red tabs. Red tabs indicate the corners. Start by attaching all of the corners of the net to the frame with the bungees and then proceed with the sides of the net until all bungees are secure.
Attach the Strike Zone Ribbon by weaving through the net and connecting the Velcro at the end. (see figure 2)
To attach the net
Use the Ground Stakes for extra stability when needed.

Use extreme caution when assembling the net to the frame. The bungees will be under extreme tension and must be attached carefully. Adult assembly is strongly recommended.