Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for TP-Link TG-5269
Summary of Contents for TP-Link TG-5269
- Page 1 TG-5269 10/100/1000Mbps Gigabit Ethernet PC Card Rev: 1.0.1 1910010048...
- Page 2 COPYRIGHT & TRADEMARKS ® is a registered trademark of Specifications are subject to change without notice. TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD.
-
Page 3: Fcc Statement
FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. -
Page 4: Table Of Contents
Package contents... 1 Chapter 1 Introduction ... 2 Product Overview ... 2 Main Features... 2 LED Status ... 2 Chapter 2 Installation ... 3 Hardware Installation... 3 2.1.1 Install driver for XP ...3 2.1.2 Update driver for XP ...9 Appendix A: Specifications... 12 CONTENTS... -
Page 5: Package Contents
If any of the listed contents are damaged or missing, please contact the retailer from whom you purchased the 10/100/1000Mbps Gigabit Ethernet PC Card for assistance. The Card or TG-5269 mentioned in this guide stands for 10/100/1000Mbps Gigabit Ethernet PC Card. -
Page 6: Chapter 1 Introduction
100Base-TX, IEEE 802.ab 1000Base-T specifications and IEEE 802.3x Full Duplex Flow. TG-5269 keeps low cost and eliminates usage barriers. It is the easiest way to upgrade a network from 10M to 100M and 1000Mbps. Supports 10Mbps, 100Mbps and 1000Mbps network speed both in Half-Duplex and Full-Duplex transfer modes, using Auto-Negotiation technology to detect the network speed. -
Page 7: Chapter 2 Installation
TG-5269 Chapter 2 Installation 2.1 Hardware Installation To install the Card, follow these steps as below: Step 1: Locate an available CardBus slot on your laptop. Step 2: With the connector pin end facing the CardBus slot and the label facing up, slide the Card into the CardBus slot until it locks in place. - Page 8 TG-5269 Step 2: Select Install from a list or specific location (Advanced) as shown in Figure 2-2, and then click Next. Step 3: Select “Don’t search. I will choose the driver to install” as shown in Figure 2-3. Then click...
- Page 9 TG-5269 Next. Step 4: Select “Show All Devices” as shown in Figure 2-4, then click Next. Step 5: Click Have Disk… in the next screen (shown in Figure 2-5), then click Next. 10/100/1000Mbps Gigabit Ethernet PC Card User Guide Figure 2-3...
- Page 10 TG-5269 Step 6: After that, select Browse… to locate the driver in the next screen. Step 7: Locate the appointed driver as shown in Figure 2-7, click Open. 10/100/1000Mbps Gigabit Ethernet PC Card User Guide Figure 2-5 Figure 2-6...
- Page 11 TG-5269 Step 8: After that, you will see the next screen (shown in Figure 2-8), click OK. Step 9: Select the model of the Card as shown in Figure 2-9, then click Next. 10/100/1000Mbps Gigabit Ethernet PC Card User Guide...
- Page 12 TG-5269 10/100/1000Mbps Gigabit Ethernet PC Card User Guide Figure 2-9 Step 10: After that, you will see the next screen, click Continue Anyway. Figure 2-10 Step 11: Finally, click Finish. And the driver installation for Windows XP completes.
-
Page 13: Update Driver For Xp
TG-5269 10/100/1000Mbps Gigabit Ethernet PC Card User Guide Figure 2-11 2.1.2 Update driver for XP If the “Welcome to the Found New Hardware Wizard” screen does not appear after you insert the Card, you can follow the steps below to install the driver, and you can also upgrade the latest driver available on the CD-ROM in this way. - Page 14 TG-5269 10/100/1000Mbps Gigabit Ethernet PC Card User Guide Figure 2-13 Step 3: Right click “TP-LINK 10/100/1000Mbps Gigabit Ethernet PC Card”, and then select “Update Driver…” in Figure 2-14. (Note: If the driver was installed correctly, you may see "Ethernet Controller" instead. Right click on it.)
- Page 15 TG-5269 Step 4: After that, the “Welcome to the Hardware Update Wizard” screen will appear, Click No, not this time, and then click Next. The following steps please refer to 2.1.1. 10/100/1000Mbps Gigabit Ethernet PC Card User Guide Figure 2-14...
-
Page 16: Appendix A: Specifications
TG-5269 Appendix A: Specifications Normal Interface 32-bit CardBus IEEE 802 .3 10Base-T, IEEE 802.3u 100Base-TX, Standards IEEE 802.ab 1000Base-T CSMA/CD Access Protocol one 10/100/1000M Auto-Negotiation RJ45 port Connector Novell NetWare3.x, 4.x, 5.x, Windows 95, Windows 98, Windows 2000, Windows NT, Windows Me, Windows XP,...