SET UP
Connecting Probes
Most low-bandwidth probes can be attached simply by pressing the connector box onto the top-row ProBus inputs. Use care when connecting
Differential High-bandwidth (DH Series) Probes to the oscilloscope ProLink or ProAxial inputs.
DHxx-PL
1. Align the probe connector box squarely with the ProLink input and
push in until you hear a click.
2. Finger-tighten the thumb screws to secure. Do not overtighten!
8
935724-00 Rev A
DHxx-PX
1. If present, remove the Planar-Crown ® -to-2.92mm adapter from the
ProAxial input.
2. Insert the probe power connector (left side) into the oscilloscope input.
Be sure the keying grooves on the connector and receptacle align.
3. Hold the connector box square to the oscilloscope input as you start to
tighten the RF connector screw (right side) to ensure proper alignment
of the thread.
4. Keeping the connector box square to the oscilloscope, finger-tighten the
Planar Crown connector screw.