1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the fan assembly (see
5.
Remove the system board with heat sink installed (see
Remove the touchpad:
1.
Remove the four Phillips M2.0 × 2.0 screws (1) that secure the touchpad bracket, and then remove the
bracket (2).
2.
Remove the protective tape from the connector on the touchpad (1).
3.
Disconnect the cable (2) from the touchpad ZIF connector.
4.
Lift the keyboard cable that covers the touchpad screws (3).
5.
Remove the Mylar that covers the screws (4).
Preparation for disassembly on page
Bottom cover on page
Battery on page
39).
Fan assembly on page
37).
46).
System board on page
52).
37).
Touchpad
55