Speakers - HP Victus Maintenance And Service Manual

4. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on
the antenna connector, as shown in the following illustration.
To install the WLAN module, reverse this procedure.

Speakers

To remove the speakers, use this procedure and illustration.
Table 6-4 Speaker description and part number
Description
Speaker Kit
Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the speakers:
1. Remove the two Phillips M2.0 × 2.0 broadhead screws (1) that secure each speaker to the computer.
2. Disconnect the speaker cables from the system board (2).
3. Remove the speakers from the computer (3) .
NOTE:
or damage to these isolators can result in degraded speaker performance.
Bottom cover on page
When removing the speakers, make note of the location of the rubber isolators. The absence of
Preparation for disassembly on page
37).
Battery on page
Spare part number
N13315-001
37).
39).
Speakers 45