HP Compaq Presario CQ58 Maintenance And Service Manual page 61

Hide thumbs Also See for Compaq Presario CQ58:

Table of Contents

Remove the TouchPad button board:

Turn the top cover upside down, with the front toward you.

Detach the TouchPad button board cable (1) from the TouchPad. (The TouchPad button board

cable is attached to the TouchPad with double-sided tape).

Release the ZIF connector to which the TouchPad board cable is connected, and then disconnect

the TouchPad board cable (2) from the TouchPad board.

Release the two pieces of shielding tape that cover the left and right sides of the TouchPad button

board (3).

Remove the two Phillips PM2.5×4.0 screws (1) that secure the TouchPad button board to the top

cover. Lift the rear edge of the TouchPad button board (2) until it rests at an angle.

Component replacement procedures

Table of Contents