6.
Remove the three Phillips M2.0 × 4.0 screws (2) that secure the fan to the computer, and then
remove the fan (3).
To install the fans, reverse these procedures.
Fingerprint reader board
To remove the fingerprint reader board, use this procedure and illustration.
Table 5-11
Fingerprint reader board description and part number
Description
Fingerprint reader board
Fingerprint reader board cable (included in Cable Kit)
Fingerprint reader insert (included in Plastic Kit)
Fingerprint reader bracket (included in Bracket Kit)
Before removing the fingerprint reader board, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the fingerprint reader board:
1.
Disconnect the fingerprint reader cable from the ZIF connector (1) on the system board.
2.
Remove the Phillips M2.0 × 2.5 screw (2) that secures the fingerprint reader bracket to the
computer.
3.
Remove the bracket (3).
52
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page
39).
37).
Spare part number
N06897-001
N56092-001
N06911-001
M21855-001
37).