3.
Detach the NFC module (3) from the computer. The NFC module is attached with adhesive.
To install the NFC module, reverse this procedure.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 5-9
Touchpad description and part number
Description
Touchpad for use in models without NFC
Touchpad for use in models with NFC
Touchpad cable (available in the Cable Kit)
Touchpad conductive tape (available in the Plastic Kit)
Before removing the touchpad, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the touchpad:
1.
Disconnect the NFC antenna cable from the ZIF connector (1) on the NFC module.
2.
Detach the NFC antenna (2) from the computer. The antenna is attached with adhesive.
Preparation for disassembly on page
Bottom cover on page
Battery on page
39).
37).
Spare part number
N60057-001
N60058-001
N56092-001
N06911-001
37).
Touchpad
49