3.
On both sides of the module, use your fingers to press down on the module until the side retention
clips snap into place (3).
Solid-state drive
To remove the solid-state drive, use this procedure and illustration.
Table 5-4
Solid-state drive descriptions and part numbers
Description
4 TB, TLC
2 TB, TLC
1 TB, TLC
512 GB, TLC
512 GB
512 GB, self-encrypting drive (SED), TLC
512 GB, lock
Before removing the solid-state drive, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the solid-state drive:
1.
Remove the Phillips M2.0 × 2.5 screw (1) that secures the drive to the computer.
42
Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
37).
Spare part number
N06219-002
M52027-002
M16560-002
M17436-002
N45476-002
M52031-002
N60315-001
Battery on page
39).
37).