Removal And Replacement Procedures For Authorized Service Provider Parts; Component Replacement Procedures; Preparation For Disassembly; Bottom Cover - HP ZBook Power G10 Maintenance And Service Manual

Table of Contents

Removal and replacement procedures for

authorized service provider parts

This chapter provides removal and replacement procedures for authorized service provider parts.

IMPORTANT:

chapter. Accessing these parts can damage the computer or void the warranty.

NOTE:

Details about your computer, including model, serial number, product key, and length of

warranty, are on the service tag at the bottom of your computer.

Component replacement procedures

To remove and replace computer components, use the procedures described in this section.

NOTE:

HP continually improves and changes product parts. For complete and current information

about supported parts for your computer, go to https://partsurfer.hp.com/partsurfer/, select your

country or region, and then follow the on-screen instructions.

Make special note of each screw size and location during removal and replacement.

Preparation for disassembly

To remove and replace computer components, use these procedures:

See

Removal and replacement procedures preliminary requirements on page 28

procedures.

Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

Disconnect the power from the computer by unplugging the power cord from the computer.

Disconnect all external devices from the computer.

Bottom cover

To remove the bottom cover, use this procedure and illustration.

Table 5-1

Bottom cover description and part number

Description

For use in models with discrete graphics memory

For use in models with UMA graphics memory

Before removing the bottom cover, prepare the computer for disassembly (see

disassembly on page

Only an authorized service provider should access the components described in this

37).