Health O Meter Professional 502KL User Instructions page 7

ASSEMBLY INSTRUCTIONS (CONTINUED)
3. Obtain the pillar column and
locate the cable connector
inside the pillar. Place the
pillar column above the
platform and cover with the
display head facing the scale
platform. Carefully pull the
cable connector from the
bottom of the pillar and plug
into the RJ jack on scale
platform. Once plugged in
completely, lower the pillar
into the cover.
Alternate Method of Plugging in the
Load Cell Cable:
If having difficulty plugging the cable
into the port, complete step 4 then
you may also access the load cell
cable via the door on the rear of the
cover. Use a Phillips screwdriver to
remove the door at the back of the
platform base then plug in the load
cell cable and replace the door.
4. Keep a firm hold on the pillar
column and platform and
place the scale on its side.
Locate the 4 column mounting
screws previously removed in
step 1. Ensure that washers
are located between the
screw heads and the scale
platform screw holes. Insert
the 4 screws through the
bottom of scale platform
screw holes and into the pillar
column. Using a Phillips head
screwdriver, tighten the
screws to secure the pillar
column to the base of the
platform.
5. On the underside of the
platform, feed the wire for the
power adapter port through
the base and plug into the
port. Note: Ensure the wire is
tucked into the slot in the base
as shown.
Alternate method to plug cable into port:
7