Table of Contents
Advertisement
Assembly
Step 2
Install the Trolley on the T-rail
• As a temporary stop, insert a screwdriver into the
hole in the front end of the T-rail.
• Slide the trolley assembly along the rail to the
screwdriver stop.
If trolley hits against any nuts on the T-rail, the
bolts and nuts were attached from the wrong
side and must be repositioned.
Review Step 1.
Temporary Stop
Screwdriver
Trolley
Stop Hole
\
Hex Screw
5/16"-18x7/8"
.ock Washer
, _
5/16"
/Nut
5/16"-18
• Insert a 5/16"-18x7/8" hex screw into the trolley
stop hole in the T-rail as shown. Tighten securely
with a 5/16" lock washer and nut. This screw limits
trolley travel in the DOWN direction.
Assembly
Step 3
I
Fasten
the T-rail to the Opener
I
Place the opener on packing material to protect
the cover. For convenience,
put a support under
the belt pulley bracket.
Remove the (2) 5/16"-18xl/2"
washered screws
mounted in the top of the opener.
Align the holes in the back section of the T-rail with
the holes in the opener.
• Fasten the rail with the (2) washered screws
previously removed. Tighten securely.
Remember
to use only these screwsl Any other
screws will cause serious damage to the opener.
• Insert a 5/16"-18x7/8" hex screw into the cover
protection bolt hole in the T-rail as shown. Tighten
securely with a 5/16" lock washer and nut.
NOTE: This screw prevents trolley over-travel.
Keep a 2" minimum between the trolley and this
screw when adjusting travel limits (see page 28).
Hardware Shown Actual Size
DHlilllilililill0
Hex Screw
NUt
Lock Washer
5/16"- 18x7/8"
5/16"
5/16"
...... _-_.. ..-?-:..:.?;.??;.??;.i:i::.
_??_.
i-! .!-i _i? !:_;il
i_iil i_ ii!_:_i_!_i
:i: i_ ii_i_ii_
_i i li__-;!:_i
!! _ "! _ !_ !;_i::i:__?
_ ' :_
.;.:.;.:.:.:. :.:.:.:.:.:.: :+:_.:.:.:.:+:.:.:.:.:.:+:;p -.:<.+._:.:5+7 ... :_:_:_:_:_:_:_:9>_:_:+:_:_`_:_÷_¢_+_+;:_:_:_:_:_>:_>P_:_
To fasten rail, use only those screws mounted
in the top of the opener. Any other screws will
cause serious damage to the opener.
Washered
Screw
5/16"-18xl/2"
Hex Screw
5/16"-18x7/8 =
Cover
Protection
Use Or#,
T-rail
(Sack Section)
5/16"
Nut
5/16"-18
Hide quick links:
Advertisement
Table of Contents
