Illustration Of One-Piece Door Installation - Craftsman 139.53664SRT2 Owner's Manual

1/2 hp
Hide thumbs Also See for 139.53664SRT2:
Table of Contents

Advertisement

:::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::
One-P ece Door without Track
Before you begin, survey your garage area to
FINISHED CEILI
see whether any of the conditions below apply
Suppo_
bracket
_
tO your
installation,
hardw&faSlsen_lguired
q
See page 17,
II _
__....._-_-Safety
_
K\\_I
Door
'
Reversln
Gap between lleor and bottom
Sensor
Safety
of door must not exceed 1/4".
ReversingSensor
One-Piece
Door with Track
Based on your particular requirements, there are
several installation steps which might call for
materials and/or hardware not included in the carton.
• Step 1, page 13 - Look at the wall or ceiling above
the garage door. The header bracket mustbe
securely fastened to structural supports.
• Step 5, page 17 - Do you have a finished ceiling in
your garage? If so, a support bracket and
additional fastening hardware (not provided) may
be required.
• Safety reversing sensor, page 21 - Depending on
garage construction,
wood blocks may need to be
securely fastened to mounting locations before
sensors are installed.
• Step 10, page 22 - Alternate floor mounting of the
safety reversing sensor will require hardware that
is not provided.
• Step 11, page 25 - Generally, a one-piece door
does not require reinforcement.
If your door is
lightweight, you can refer to the information
relating to sectional doors on page 24.
• Step 11, page 25 - Depending on your door's
construction,
you might need additional mounting
hardware for the door bracket.
• Do you have an access door in addition to the
garage door? If not, Model 53702 Emergency Key
Release is required. See page 38.
• The gap between the bottom of the garage
door and the floor cannot exceed 1/4".
Otherwise, the safety reverse system may not
work properly. See page 30, The floor or the door
should be repaired.
Floor must be level
.
across width of door
Reversing
Sensor
Garage -
Door
Closed Position
Belt
Belt
Trolley
_-_'ulley Bracket
j
_"Header
Curved
_
J
Bracket ooDooor oAo ,nno o o_
IT-T-rail
J
|
Emergency
Release
Door
Straight
Rope & Handle
Brackaf Door't
_//j
Arm
You may find it helpful to refer back to this page
as you proceed with the installation of your
opener.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents