Table of Contents
Advertisement
_!:_:_:::
__:_:_ _" ; :;_":::
::::_i_
:¸:::::::I!_!_!I!_:_!I!_!_!_;
_i:'::!_!i:_:_ii:_:i::'::i:i:_::''_.:_:i::':'_
_:i:_:i:_:_:i
E"":"__:_$_:i:F.:i:_ ::_:':i:_::i:
_i:i:_:_i
Please read and comply
with the warnings
and reinforcement
instructions
on page 24.
They apply to one-piece
doors also.
Header Wall
-- Finished Ceiling --
2x4 Support
Header
Bracket
Bracket
Placement
of Door
Bracket
Vertical
Garage Door
Horizontal and vertical reinforcement is
needed for lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc.).
(Not Provided)
Nut
5/16"-18
i_
I
I
Door
--
_
5/16"
Top o! Door
(Inside Garage)
_
Top Edge
of Door
__
Optior_
Placement
I
I
For a door with no
i
L
Carriage Bolt
exposed lramlng or for
5/16"-18x2-1/2"
the optional Installation,
use 5/16"x1-1/2'
lag
screws(not provided)
• Center the bracket on the top of the door, in line
with the header bracket as shown. Mark holes.
• Drill 5/16" pilot holes and fasten the door bracket
with hardware supplied.
If the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"xl-1/2"
lag
screws (not provided) to the top of the door.
The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement
drawing.) Drill 3/16" pilot holes and substitute
5/16"x1-1/2" lag screws (not provided) to fasten
the bracket to the door.
Hardware Shown Actual Size
©
©
5/16"-18x2-1/2"
25
Hide quick links:
Advertisement
Table of Contents
