Electrical Requirements - Craftsman 139.53664SRT2 Owner's Manual

Installation Step 9 I
Electrical Requirements
I
To reduce the risk of electric shock, your garage
door opener has a grounding type plug with a third
]rounding pin. This plug will onlyfit into a grounding
type outlet.
If the plug doesn't fit into the outlet you have,
contact a qualified electrician to install the proper
outlet.
To avoid installation difficulties,
do not run the opener at this time,
To prevent electrocution or fire, installation
and wiring must be in compliance with local
electrical and building codes.
Do NOTuse an extension cord, 2-wire adapter,
or change the plug in any way to make it fit
your outlet.
If permanent wiring is required by your local code, refer to the following procedure:
To make a permanent connection through the
7/8" diameter hole in the top of the opener
(according to local code):
• Remove the opener cover screws and set the
cover aside.
• Remove the attached 3-prong cord.
• Connect the black (line) wire to the screw on the
brass terminal; the white (neutral) wire to the
screw on the silver terminal; and the ground wire
to the green ground screw. The opener must be
grounded.
• Reinstall the cover.
To avoid installation difficulties,
do not run the opener at this time.
GroundTab
Green
Screw
Wire
Permanent
Wiring
Connections
Black
i Wire
White Wire
Wire
2O