Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Strongway 46208
Summary of Contents for Strongway 46208
- Page 1 2-TON HIGH POSITION HOIST STAND OWNER’S MANUAL WARNING: Read carefully and understand all ASSEMBLY AND OPERATION INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item# 46208...
-
Page 2: Intended Use
Thank you very much for choosing a Strongway product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. -
Page 3: General Safety Rules
GENERAL SAFETY RULES WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in serious injury. CAUTION: Do not allow persons to operate or assemble this product until they have read this manual and have developed a thorough understanding of how the product works. WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. - Page 4 ASSEMBLY Use the exploded drawing as your guide to assemble, Lay all parts and assemblies out in front of you before beginning. The following procedure is recommended: All numbers in parenthesis () refer to the index number from the parts breakdown. 1.
- Page 5 7. Connect the outer pillar (NO.18) to the saddle 5. Mount the L-brackets (NO.8) with the support base (NO.2). To adjust the position of the jack pillar (NO.3), using the screws (NO.9), washers stand, use the Lock Bolt (NO.15), Washer (NO.10) and the nuts (NO.11), then tighten the (NO.16) and Hitch Pin Clip (NO.17).
- Page 6 OPERATING INSTRUCTIONS RAISING THE HOIST STAND 3. Carefully position stand so that load is centeredon stand’s saddle. 1. Adjust height by rotating the handle CLOCKWISE. 4.Raise saddle to vehicle support point vehicle,continue to rotate handle clockwise until loadsupport point is secure. Do not raise any higherthan load stability will allow.
- Page 7 LOWERING THE HOIST STAND LUBRICATION 1. Ensure that all tools, equipment and personnel A periodic coating of light lubricating oil to pivot are clear before lowering load. points will help to ensure that pump piston linkages move freely. 2. DO NOT EVER LOWER STAND UNLESS Note: Never apply oil to the saddle.
-
Page 8: Maintenance Instructions
MAINTENANCE INSTRUCTIONS Maintain your equipment. It is recommended that the general condition of any equipment be examined • before it is used. Keep your equipment in good repair by adopting a program of conscientious repair and maintenance. Have necessary repairs made by qualified service personnel. •... -
Page 9: Parts Diagram
PARTS DIAGRAM... -
Page 10: Parts List
PARTS LIST REF# PART# DESCRIPTION GB5781-M10x25 Hex head screw M10x25mm Saddle base Support bar GB97.1-M10 Washer M10 GB6170-M10 Nut M10 GB5781-M10x20 Hex head screw M10x20mm Guide plate L-bracket GB5781-M8x20 Hex head screw M8x20mm GB97.1-M8 Washer M8 GB6170-M8 Nut M8 GB5781-M8x16 Hex head screw M8x16mm Short pull rod Long Pull rod... - Page 11 Northern Tool and Equipment Company, Inc. ("We'' or '"Us'') warrants to the original purchaser only ("You'' or “Your”) that the Strongway product purchased will be free from material defects in both materials and workmanship, normal wear and tear excepted, for a period of one year from date of purchase.