g.
Leave the computer upside down on the table for 20 minutes to allow the adhesive to set.
h.
Position the computer upright on a table.
i.
Leave the computer upright on the table for 10 minutes to be sure that the panel sits correctly in
the display.
10.
If you need to remove the camera module:
Use a tool to lift up evenly across the module and peel the module up from the display back cover
■
(1), and then disconnect the cable or cables from the reverse ZIF connector on the module (2). The
camera module is available as spare part number N05869-001 for HD cameras and N05870-001 for
IR cameras. The microphone module is available as spare part number N05863-001.
NOTE:
For installation, note that the cable routes under the camera module before it connects to
the module.
HD camera shown in the following illustration.
Display assembly
67