Power Connector Cable - HP Probook 450 G9 Maintenance And Service Manual

2. Lift the speakers straight up to remove them (2).
Reverse this procedure to install the speakers.

Power connector cable

To remove the power connector cable, use this procedure and illustration.
Table 6-10 Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the power connector cable:
1. Move the antenna cables that route over the right screw (1).
2. Remove the three Phillips M2.5 × 4.0 screws (2) that secure the right display hinge to the computer, and
then rotate the hinge off the power connector (3).
3. Disconnect the cable from the system board (4).
Preparation for disassembly on page
Bottom cover on page 40).
40).
Battery on page 50).
Power connector cable
Spare part number
M21725-001
61