Table of Contents
Advertisement
Chapter 9: System Configuration
Chapter 9: System Configuration
This chapter describes how to configure your StorEdge system by setting up the communication
between the system components and setting up the required a pplication.
Configuring the RS485 Bus for Battery and Meter
Connection
This section describes how to set up the RS485 communication between the i nverter, meter and battery.
Some inverters are equipped with a built-in Revenue Grade Meter (RGM), which is located in the StorEdge
Connection Unit. When an additional meter is installed for these inverters, the second meter is
connected to the existing RGM in a daisy chain.
To configure the RS485 bus:
1. Turn OFF or verify that the StorEdge Connection Unit switch i s OFF.
2. Turn the inverter ON/OFF switch to OFF.
62
SolarEdge-StorEdge Installation Guide MAN-01-00262-1.0
Advertisement
Table of Contents
Troubleshooting
