Health O Meter 3423 Manual page 8

ASSEMBLY INSTRUCTIONS (CONTINUED)
2. Remove the 4 column
mounting screws and washers
from the bottom of column B
and set aside for assembly
step 7.
3. Locate the load cell connector
cable inside column A. While
holding column B, slide the
cable through the center
opening at the top of column
B. Push the cable all the way
through Column B until the
plug reaches the bottom of the
column.
4. Align column A and column B.
Notches are located at the
bottom of column A and the
top of column B. Snap the
locking tab into place. Ensure
that the locking tab is locked
securely into place. Note:
When aligning and locking
the columns, use caution
not to pinch the load cell
connector cable.
Screws and washers
Column B
(top)
Column B
(top)
Column B
(top)
Notches
Locked position
7
Back to Home Page
Column B
Column A
(bottom)
Load cell
connector
cable
Column A
(bottom)
Locking tab