Advertisement
INSTALLATION OPERATIONS.
Before installing the Domus Container, it is necessary to remove the
front door (1) and the fixed casing (2) by loosening the appropriate
screws (3).
Release the fixed casing (2) from the stop screws on the frame by push-
ing upwards and at the same time pulling it towards you.
N.B.: to remove the front door (1) after having loosened the appropriate
screws (3), grip the handle (1a) with your left hand and the knob (1b)
with your right hand.
• Proceed by levelling the Domus Container using the provided lev-
elling feet (4).
• Make 4 Ø 10 mm holes on the wall in correspondence with the holes
of the brackets (5).
• Fix the Domus Container on the wall using the Ø10x60 wall plugs
(6), screws (7) and nuts (8) supplies (Fig. 3).
Attention: check that the frame remains in square during the fixing
operations.
Once the frame has been installed, set up all the connections for the
hydraulic connection to the specific product preset in the lower and
lateral part.
Installation drawings key:
Unique identification of the component
1
in the kit
A
Identification of the component not
supplied in this kit
N.B.: The connection unit is not supplied, but is sold separately (Op-
tional). To ease installation, choose whether to make the connection
at the rear, bottom or side (bottom right) of the Domus Container kit
(see Fig. 2).
The electrical connections require the connection to the electric mains
to be separated from the connection to the temperature control for the
cables to reach the various template references.
Make the gas connection (where required). The gas pipe can exit
through the rear outlet, the lower outlet, the right side outlet.
N.B.: to install the gas supply pipe, under or out of route, comply with
the installation standards UNI 7129 / 7131-99.
Install the connecting pipes of the coolant gas circuit (where required)
using the pre-drilled holes. The pipes inside the Domus Container kit
must protrude as necessary to allow the chosen product to be connected.
N.B.: Comply with the UNI EN 378 Standards for the installation of
the coolant gas circuit and connection to the heat pump.
5
7
8
7
8
3
7
8
3
4
2
11
6
5
6
5
3
6
5
3
1a
3
4
6
7
8
1b
1
Fig. 3
Advertisement
