Advertisement
Quick Links
Advertisement
Related Manuals for Immergas 3.022167
Summary of Contents for Immergas 3.022167
- Page 1 COD. 3.022167 KIT DOMUS Instruction and warning book CONTAINER...
-
Page 2: General Warnings
Read the instructions provided with the product carefully to ensure proper installation. the Immergas kit. As for the other issues related to kit installation (e.g. Installation and maintenance must be performed in compliance with the... - Page 3 CONNECTION TEMPLATE. ATTENTION: The indicated height measure- ments refer to the minimum adjustment of the feet from the ground (35 mm). REAR CONNECTION RIGHT HAND SIDE CONNECTION LOWER CONNECTION Key: G - Gas supply LP2 - Chiller line - liquid phase (Trio Pack) AC - Domestic hot water outlet AF - Domestic hot water inlet...
-
Page 4: Kit Description
The top is completely open. With the presence of boilers, the upper part is completely open for the outlet to the flue (“B type” and “C type” installations) and the intake duct (only for “C type” installation) using the Immergas flue. - Page 5 INSTALLATION OPERATIONS. N.B.: The connection unit is not supplied, but is sold separately (Op- tional). To ease installation, choose whether to make the connection Before installing the Domus Container, it is necessary to remove the at the rear, bottom or side (bottom right) of the Domus Container kit front door (1) and the fixed casing (2) by loosening the appropriate (see Fig.
- Page 6 Attention: Refer to the specific instruction booklet of each individual • In order to easily install the products inside the Domus Container, it is recommended to temporarily remove the appliance front met- product for assembly/installation and commissioning of the various al-sheet plate (9), the storage tank unit front metal-sheet plate (10) components inside the Domus Container kit.
- Page 7 N.B.: the vertical position of the door can be adjusted using the slots Once installation is completed, the previously removed casing and front door can be reassembled. (1d). Hook the fixed casing (2) back onto the screws with stop on the frame N.B.: if the front door (1) is not aligned with the frame, a further and tighten the fixing screws.
- Page 8 Per richiedere ulteriori approfondimenti specifici, i Professionisti del settore possono anche avvalersi dell’indirizzo e-mail: consulenza@immergas.com To request further specific details, sector Professionals can also use the following e-mail address: consulenza@immergas.com Immergas S.p.A. 42041 Brescello (RE) - Italy Tel. 0522.689011 Fax 0522.680617...