Immergas MAGIS HERCULES PRO MINI 6 Instructions And Recommendations page 8

Check the environmental operating conditions of all parts relevant to installation, referring to this booklet.
If installing a kit or servicing the appliance, always empty the system's domestic hot water circuit first so as not to compromise
the appliance's electrical safety (Par. 2.9, 2.10).
Always disconnect the appliance from voltage and, depending on the type of operation, decrease the pressure and/or bring it to
zero in the gas and DHW circuits.
Before installing the appliance, ensure that it is delivered in perfect condition; if in doubt, contact the supplier immediately.
Packing materials (staples, nails, plastic bags, polystyrene foam, etc.) constitute a hazard and must be kept out of the reach of
children.
If the appliance is installed inside or between cabinets, ensure sufficient space for routine servicing; for minimum installation
distances, see Fig. 2.
Keep all flammable objects away from the appliance (paper, rags, plastic, polystyrene, etc.).
Any modification to the appliance that is not explicitly indicated in this section of the booklet is forbidden.
Installation standards
This appliance must be installed indoors or outdoors in a partially protected area where the temperature cannot drop below 0
°C.
By partially protected area, we mean one in which the appliance is not directly exposed to the elements (rain, snow, hail, etc.).
This type of installation is possible when permitted by the laws in force in the appliance's country of destination.
Do not install in places/rooms that constitute public areas of apartment buildings, internal
stairways or other escape routes (e.g. floor landings, entrance halls, etc.).
To prevent electrocution, fire or injury, always switch off the unit, disable the protective switch
and, if smoke escapes or if the unit is extremely noisy, contact the Authorised After-Sales Tech-
nical Assistance Centre.
Do not install near sources of heat.
Pay attention not to generate sparks as follows:
– Do not remove the fuses while the unit is on.
– Do not unplug the unit while it is on.
It is recommended to install the outlet high up. Lay the cables in such a way that they do not get
tangled.
This indoor unit is used to heat water to below boiling temperature in atmospheric pressure.
8