Cleaning And Maintenance; Control Panel; System Use - Immergas MAGIS HERCULES PRO MINI 6 Instructions And Recommendations

At the end of its service life, the appliance must not be disposed of like normal household waste
nor abandoned in the environment, but must be removed by a professionally authorised com-
pany as required by current legislation.
Contact the manufacturer for disposal instructions.

2.2 CLEANING AND MAINTENANCE

To preserve the system's integrity and keep the safety features, performance and reliability, which distinguish the assembly,
unchanged over time, you must execute maintenance operations on a yearly basis in compliance with what is stated in the rela-
tive point at "annual check and maintenance of the appliance", in compliance with national, regional, or local standards in
force.

2.3 CONTROL PANEL

1
20 19
Key (Fig. 28):
1 - Display.
2 - "DHW (Domestic hot water)" menu button.
3 - "Zones" button.
4 - Functioning mode button.
5 - ON/OFF Button.
6 - Zones area (number and information of zone in use).
7 - Operating mode.
8 - Anomaly code/flow temperature display.
9 - System general icon display.
10 - Central heating / C.H. set display.
2.4

SYSTEM USE

Before ignition, make sure the system is full of water, checking that the pressure gauge needle (Fig. 28) points to a value between
1 and 1.2 bar and make sure that the chiller circuit has been filled as described in the outdoor unit instructions booklet.
The following are displayed upon ignition:
- Type of panel;
- Panel firmware version;
- Board firmware version.
18 17 16
6
15 14 13
11 - Current date and time display.
12 - System state button.
13 - Heat pump power scale button.
14 - DHW (Domestic hot water) set display.
15 - Pressure gauge.
16 - "Heating/cooling set" knob.
17 - Selection confirmation/ok button.
18 - "Menu" Button.
19 - Anomalies/esc. reset button.
20 - "Set DHW (Domestic hot water)" Knob.
7 8 9
12 11 10
28
33