Temperature Control Setting - Immergas MAGIS HERCULES PRO MINI 6 Instructions And Recommendations

1.14 TEMPERATURE CONTROL SETTING

By setting the parameters in the menus
Zones/Configuration
it is possible to automatically adjust the flow temperature of each zone according to the outdoor temperature.
This can be done by enabling the external probe modulation in the menu
Zones/Enablings
The curves (Fig. 16, 17, 18, 19) show the default settings in the various operating modes available both with external probe and without.
Zone flow temperature in central heating mode / C.H. mode
and external probe modulation enabled
A
B
C
Zone flow temperature in cooling mode
and external probe modulation enabled
A
B
C
Key (Fig. 16, 17, 18, 19)
A - Maximum flow set
B - Minimum flow set
C - External minimum temperature
D - External maximum temperature
24
E
D
G
D
Zone flow temperature in central heating mode / C.H. mode
and external probe modulation absent
16
Zone flow temperature in cooling mode
and external probe modulation absent
18
E - C.H. flow temperature offset
F - Central heating / C.H. flow set
G - Cooling flow temperature offset
H - Cooling flow set
F
H
17
19