Parameters For Filling In The Package Fiche - Immergas MAGIS HERCULES PRO MINI 6 Instructions And Recommendations

4.6

PARAMETERS FOR FILLING IN THE PACKAGE FICHE

Should you wish to install an assembly starting from the Magis Hercules Pro Mini package, use the package fiche shown in (Fig. 52).
To fill it in correctly, enter the figures shown in tables in par. "Parameters to fill in the low temperature package fiche (30/35)", "Parameters
to fill in the average temperature package fiche (47/55)" (as shown in the package fiche facsimile Fig. 51).
The remaining values must be obtained from the technical data sheets of the products used to make up the assembly (e.g. solar devices,
integration heat pumps, temperature controllers).
Use board (Fig. 52) for "assemblies" related to the central heating mode (e.g.: heat pump + temperature controller).
Since the product is standard supplied with a temperature controller, the package fiche must always be completed.
Facsimile for filling in the package fiche for room central heating systems.
Temperature control
From temperature
control board
Supplementary boiler
From boiler board
Solar contribution
From the board of the solar device
Dimensions of the
manifold (in m
( 'III' x
climate conditions
climate conditions
Colder:
the heat loss in the distribution system and the size of the products compared to the size and
features of the building.
Class I = 1 %, Class II = 2 %,
Class III = 1.5 %, Class IV = 2 %,
Class V = 3 %, Class VI = 4 %,
Class VII = 3.5 %, Class VIII = 5 %
Volume of the
) tank (in m )
2 3
+ 'IV' x ) x 0.45 x (
G F E D
< 30 % ≥ 30 % ≥ 34 % ≥ 36 % ≥ 75 % ≥ 82 % ≥ 90 % ≥ 98 % ≥ 125 %≥ 150 %
%
- 'V' =
(%)
( - 'I' ) x
tank
A* = 0.95, A = 0.91,
B = 0.86, C = 0.83,
manifold (in %)
D-G = 0.81
/ 100) x
C B A A
+
ter climate conditions
Hotter:
%
'I'
+
%
-
%
"II" =
+
%
=
%
A A
++ +++
%
+ 'VI' =
51
111