Step 3: Verifying Proper Activation And Commissioning; Reporting And Monitoring Installation Data - SolarEdge SE15K Installation Manual

51 Step 3: Verifying Proper Activation and Commissioning
Select Site Communication to configure communication between multiple
SolarEdge devices or external non-SolarEdge devices, such as batteries or loggers.
Power Control
Step 3: Verifying Proper Activation and
Commissioning
1. Select Information and verify that the correct firmware versions are installed on each
inverter. To save the information to a read-only file, tap the PDF icon (iOS) or the
JPEG icon (Android) at the bottom of the screen.
2. Select Status and verify that inverter is operating and producing power.
3. Verify that additional configurations were properly set by viewing the relevant
Status screens.
4. Verify that the green inverter LED is steadily lit.
Your SolarEdge power harvesting system is now operational.

Reporting and Monitoring Installation Data

Monitoring the site requires connecting the inverter to the monitoring platform, using
any of the wired or wireless options available from SolarEdge. Refer to Setting Up
Communication with the Monitoring Platform on page 37.
The Monitoring Platform
The monitoring platform provides enhanced PV performance monitoring and inverter
yield assurance through immediate fault detection and alerts at the module, PV array
and system level.
Using the platform, you can:
View the latest performance of specific components.
Find under-performing components, such as modules, by comparing their
performance to that of other components of the same type.
Pinpoint the location of alerted components using the physical layout.
The monitoring platform enables accessing site information, including up-to-date
information viewed in a physical or logical view:
Logical Layout: Shows a schematic tree-layout of the components in the system,
such as: inverters, Power Optimisers, PV arrays, modules, meters and sensors, as
well as their electrical connectivity. This view enables you to see which modules are
Three Phase Inverter with SetApp Configuration