Maintaining Your Brush Bar - Dyson 360 Vis Nav User Manual

Maintaining your brush bar

To maintain optimum performance, check and remove hair and debris from
your brush bar at least once a month.
Remove your brush bar
Don't put any part of your machine in a dishwasher or use detergents,
polishes or air fresheners.
Turn your robot over and place it on a soft surface.
Lift the red brush bar cover lever on the base of your robot and then press
the red brush bar release button.
Slide the brush bar out of your robot and remove any threads wrapped
around the brush bar. Remove debris from the brushbar recess,
including any threads wrapped around the rotating parts.
Pull the silver end cap from the brush bar and remove any threads from
the recess. Don't wash the end cap.
Wash and dry your brush bar
If your brush bar needs washing, hold your brush bar under running water
and gently rub to remove any lint or dirt.
Remove as much excess water as possible. Run your hand down the length of
the brush bar to squeeze out the water.
Stand your brush bar upright. Leave to dry completely for at least 24 hours.
Important: your brush bar must be completely dry before you put it back into
the machine. Your machine could be damaged if used with a damp brush
bar.
Replace your brush bar
Before replacing, check that your brush bar is completely dry.
Push the end cap back onto the brush bar. Slide the brush bar back into your
robot, push down on it until the release button pops back up.
Close the brush bar cover and push the lever down to lock the cover in place.
Locate the brush bar lever
on the base of the robot
near the centre and above
the brush bar
Slide and lift the
brush bar out
from one end and
remove whole
component