SolarEdge SEXXXXH-RWMBNBF54 Quick Installation Manual

SolarEdge
Home Hub Inverter - Single Phase
Quick Installation Guide
for Europe models SEXXXXH-RWMBNBF54
What's in the Package
Inverter Wall mount bracket
WARNING!
This symbol denotes a hazard. It calls attention to a procedure that if not correctly
performed or adhered to could result in injury or loss of life. Do not proceed beyond
a warning note until the indicated conditions are fully understood and met.
CAUTION! Denotes a hazard. It calls attention to a procedure that, if not correctly
performed or adhered to, could result in damage or destruction of the product. Do not
proceed beyond a caution sign until the indicated conditions are fully understood and met.
A Mounting
Optional
Holes
3
2
Wiring
B
PV String(s)
2
Important Note: This PV
string is only available for
models SE8000H and above
SolarEdge Home Battery 400V
SolarEdge Home
Network Antenna
1
Ø 9mm
Optional
4 N*m
4
5
4 N*m
6
WARNING! Connect a
ground cable if required
by local regulation.
6 N*m
3
solaredge.com
SolarEdge Technologies GmbH, Werner-Eckert-Str. 6, 81829 Munich, Germany
Subject to change without notice.
© SolarEdge Technologies, Ltd.
All rights reserved. July 2023. Rev 1.2
WARNING!
To avoid danger, read the HANDLING AND SAFETY
INSTRUCTIONS provided with this product, or refer to:
https://www.solaredge.com/sites/default/files/se_handling_and_saf
ety_instructions.pdf
Before installation, read the datasheet provided with this
product, or refer to:
center.solaredge.com/sites/kc/files/se-home-hub-single-phase-
inverter-datasheet-eu.pdf
Tools and Materials
Drill
Pencil
Open-end 10mm
Torque wrench
torque wrench
with 4 mm Allen bit
20 cm
20 cm
20 cm
CAUTION! DO NOT rest the inverter vertically on the connectors
1
AC Grid
L N GND
NOTE:
Use a protective device
according to regulation
https://knowledge-
Level
MC4 crimper Wire Cutter
Small Flat-Blade
Phillips/Flat-
(2mm)
Blade
Screwdriver
screwdriver set
20 cm
1
4
5
6
7
3
2
1
4
3
2
WARNING!
HAZARD OF ELECTRIC SHOCK.
DISCONNECT POWER BEFORE INSTALLATION OR SERVICE
WARNING!
Connect the grounding wire first
WARNING!
Make sure to use a
protective device with a rating of 28A
(50A for SE8000H and above).
Do NOT connect a protective device
with a higher rating than 50A (80A for
SE8000H and above).
Hammer
min 2
Mounting screws and
wall plugs - max M10
1-10 mm 2
18 mm
60 mm
9-21 mm