Installation Instructions - Winegard AIR 360 PLUS 5G Installation & Operation Manual

Installation Instructions

Safety Recommendations
Do not attempt to install this system in the rain or under any wet
conditions.
Do not paint this antenna. Painting the antenna will void the warranty.
OTA cable
Ethernet cable (optional)
Gateway power cable
+12V DC
3A fuse
To ANT IN
TV out 2
TV out 1
ANT IN
Before mounting the antenna, determine locations for both the TV antenna
wall plate/power supply and Gateway 5G wall plate/power supply. Keep in
mind the following:
• Coaxial cables will have to run from the HDTV wall plate/power supply to the
antenna and from the wall plate to each television.
• If using the Air 360 Plus 5G to receive FM stations, an additional coax cable
(not provided) will have to run from the wall plate (TV OUT 1 or 2) to the
coax to audio cable (provided) and into the radio.
• Coax cables will have to be routed through the roof, directly under the
perimeter of the antenna. It will not seal correctly for the cables to exit
under the flange. Failure to install correctly could cause damage to the
antenna and possibly the RV.
1"-3" hole in roof
Red wire
to switch
Black wire
to ground
+12V DC
Ground
Gateway 5G
Sold separately
Prewire hole cover
–5–
WiFi/5G cables
7" max roof thickness
1" hole in ceiling
Must be directly
below hole in roof