Tv Antenna Operation - Winegard AIR 360 PLUS 5G Installation & Operation Manual

TV Antenna Operation

First-time users must run a channel scan on your
TV to receive maximum programming.
Ensure the antenna power supply (wall plate) is
in the "ON" position and the green indicator light is
illuminated.
A channel scan will find all available channels
in your area, including any new channels and
subchannels that have been added in your area
since the last scan.
While the steps to perform a channel scan may vary
between televisions or compatible devices, the
steps below are some general guidelins to follow.
Channel Scan
– Using the television remote, select "Menu" and then "Settings."
– Select "Channel Setup."
– Select "Antenna" or "Air," depending on your TV. Make sure you are not
on "Cable."
– Select "Channel Search" or "Channel Scan." Keep in mind that steps
to perform a channel scan may vary. If the wording in your TV differs
from the options shown, refer to your TV user manual for help.
NOTE: Running a channel scan is NOT the same as pressing Channel UP/
DOWN on your remote.
To receive maximum programming, you have to run a channel scan after
setting up the antenna. To keep your channel line-up up-to-date, it is a good
idea to run a channel scan monthly, anytime a channel is lost, and anytime you
change locations.
Gateway 5G Operation
See Gateway Installation and Operation Manual.
–11–
Power indicator light is
green when power is on.
Power button