Flashing Display Lights; Using The Dishwasher - GE GSD6000 Owner's Manual

Flashing display lights.

Status Indicator Lights
START/RESET

Using the dishwasher.

Check the Water Temperature
The entering water should be at least 120°F and not
more than 150°F, for effective cleaning and to prevent
dish damage. Check the water temperature with a
candy or meat thermometer. Turn on the hot water
faucet nearest the dishwasher, place the thermometer
in a glass and let the water run continuously into the
glass until the temperature stops rising.
Use Jet-Dry
Jet-Dry ®
rinse agent removes spots and prevents new film build-up on
your dishes, glasses, flatware, cookware and plastic.
Filling the Dispenser
The rinse agent dispenser holds 3.5 oz. of rinse agent. Under normal
conditions, this will last approximately one month. Try to keep it full,
but do not overfill.
Make sure the dishwasher door is fully open.
1
Turn the dispenser knob to the left and lift it out.
2
Add rinse agent until the indicator window looks full.
3
Clean up any spilled rinse agent with a damp cloth.
4
Replace the dispenser knob.
5
Rinse Aid Setting
The amount of rinse agent released into the final wash can be adjusted.
The factory setting is at the midpoint. If there are rings of calcium
(hard water) spots on dishes, try a higher setting.
To adjust the setting
Remove the dispenser knob, then turn the adjuster counterclockwise
to increase the amount of rinse agent.
Dish Preparation Prior to Loading
s No pre-rinsing of normal food soil is required.
s Scrape off hard soils, including bones,
toothpicks, skins and seeds.
s Remove large quantities of any remaining
food.
6
What It Means
Cycle has been interrupted by pressing the START/RESET pad. Light will quit
flashing after the dishwasher automatically drains out the water.
Rinse Agent
®
Indicator
window
s Remove leafy vegetables, meat trimmings, and
excessive amounts of grease or oil.
s Remove acidic food soils that can discolor
stainless steel.
Dispenser cap
Rinse agent
adjuster