5.
Remove the four Phillips M2.0×3.0 screws (5) that secure the TouchPad and TouchPad bracket to
the keyboard/top cover.
6.
Remove the TouchPad bracket (6).
The TouchPad bracket is available using spare part number 857825-001.
7.
Remove the TouchPad (7).
Reverse this procedure to install the TouchPad.
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Disconnect the battery cable from the system board (see
Remove the power connector cable:
1.
Remove the three Phillips M2.0×4.8 screws (1) that secure the power connector cable bracket to
the keyboard/top cover.
2.
Remove the power connector cable bracket (2).
38
Chapter 5 Removal and replacement procedures
Bottom cover on page
26).
Spare part number
857437-001
Battery on page
28).