Table of Contents
Advertisement
5.
Remove the optical drive brackets (2).
Reverse this procedure to reassemble and install the optical drive.
TouchPad
Description
TouchPad
NOTE:
The TouchPad spare part kit does not include the TouchPad bracket or TouchPad cable.
The TouchPad bracket is available using spare part number 857825-001. The TouchPad cable is available
using spare part number 857836-001.
Before removing the TouchPad, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
6.
Remove the optical drive (see
Remove the TouchPad:
1.
Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable from the system board.
2.
Detach the TouchPad cable (2) from the TouchPad. (The TouchPad cable is attached to the TouchPad
with double-sided adhesive.)
3.
Detach the pieces of grounding tape (3) that secure the TouchPad to the keyboard/top cover.
4.
Remove the three Phillips M2.0×2.3 broad head screws (4) that secure the TouchPad and TouchPad
bracket to the keyboard/top cover.
Bottom cover on page
Battery on page
28).
Optical drive on page
26).
36).
Component replacement procedures
Spare part number
857830-001
37
Advertisement
Table of Contents
